www.flightsim4fun.com - rksoftware

I've switched them around and all is good now, thank you. Now it is just the Opencockpits MCP which does not work?

I've now tried the following in order to try get the MCP to work:-

I open SIOC Monitor. I highlight MCP under "Script Device IDX Detected" and I then highlight IOCard-MCP under "Devices Connected". I then change "Script Device IDX from -1 to 15, I click okay, and they are linked! I then "Save and Exit". I then exit the program and restart it again to allow the new settings to take effect.

When I restart these settings are lost and it shows that the MCP is no longer linked..........

Any other ideas to try?

You should not use the SIOC configuration subprogram!

If you have the MCPv2 and not MCPv3 change the MASTER line for the MCP in the XPLANE.ini
as stated in the doc

[*]
[X-PLANE 11]
CONFIG_FILE=OCP4B737_XP.ssi
MASTER=15,15,1,58 // MCPv3 If you have MCPv1/MCPv2 modify to MASTER=15,5,1,xx

It works, all sorted! Apologies for not reading the instructions thoroughly, I missed that part! Thank you for always being there to assist so quickly and efficiently! It is really appreciated! You are a star! I have marked it as SOLVED!