Hi everyone
I have a working full size 737 sim currently running:
P3Dv5
Opencockpit modules - MCP, EFIS (CO & FO), CDU (CO & FO), FWD OVH, Pedestal
TQ (non-motorised)
I have Xplane11 installed with Ortho scenery for all of New Zealand and having spent 32 years in NZ before returning to the UK to retire I find great enjoyment flying over NZ and seeing it as it is.
I would like to know what is required to run XP with Zibo (which I have) using OC4BA (I believe I need OC4BA_XP) and Open Cockpit modules.
Is there a place you could point me to with the info to help?
Thanks very much in anticipation
Mike
Building a full cockpit with XP
Re: Building a full cockpit with XP
OC4BA_XP today supports MCP, CDU1/FMC1, CDU2/FMC2, EFIS1, EFIS2, COM1, COM2, NAV1, NAV2 and ATC for the Zibo 737 airplane in XPLANE11.
Support for the other OC modules, OVH-FWD, OVH-AFT, MIP, and other Pedestal are not planned at this time, but it could change if I see a higher request for added modules to
the existing OC4BA_XP release. So far, the request is very low compared to OC4BAv5 for the FSX and P3D platforms.
If someone would like to sponsor support for other modules, I could add them in a few weeks.
What other solutions that are available I do not know, as I am not using XPLANE a lot myself.
Support for the other OC modules, OVH-FWD, OVH-AFT, MIP, and other Pedestal are not planned at this time, but it could change if I see a higher request for added modules to
the existing OC4BA_XP release. So far, the request is very low compared to OC4BAv5 for the FSX and P3D platforms.
If someone would like to sponsor support for other modules, I could add them in a few weeks.
What other solutions that are available I do not know, as I am not using XPLANE a lot myself.