No Panel State Options For New Paints
Posted: Sat May 04, 2019 10:38 pm
So far I've been using 737-800WL with smart starter with no issues. Been working great.
Today I installed some new paints for the 737-800 model. In P3D I loaded up one of the planes and set my displays up on the monitors and saved a new Scenerio file to use for this model. In SmartStarter settings, I added the 800NGX and linked it to the new scenario for it.
But when I try to setup a flight, the panel state dropdown has no options in it. Not sure if why. The panel states only show for the oritinal 800NGX WL planes I had in there.
Any ideas?
Thanks,
Shaun
Today I installed some new paints for the 737-800 model. In P3D I loaded up one of the planes and set my displays up on the monitors and saved a new Scenerio file to use for this model. In SmartStarter settings, I added the 800NGX and linked it to the new scenario for it.
But when I try to setup a flight, the panel state dropdown has no options in it. Not sure if why. The panel states only show for the oritinal 800NGX WL planes I had in there.
Any ideas?
Thanks,
Shaun