www.flightsim4fun.com - rksoftware

Hi. I want to combine 2 scripts, one of this OVHD and another one MIP.
I make each one for separately. Then I open SIOC-edit script-group-run and I think a new script is created.
But, after when I configure OCBBA I choose the new script, the module, and in 4 box operations , what I have to select in here?
OVH-FWD and MIP?
What is the right way to do it?
Thnks.

In order to make this correct, you must fully understand the SIOC handling of hardware and software.

If you have both OVH and MIP functions defined to the same Expansion/Master cards you should do the following:

As the IDX number is the device number in your script, i.e. 30

In the OC4BAv4.ini, if you have 3 Master cards
Delete OVH-FWD IDX30m2
Add OVHMIP IDX30m3


Then you select OVHMIP as Operations when you set up your configuration.

Hope this was clear enough.

Hi. Thanks for the answer. Í undertand it. The problem now is the following: when I run in the sioc-edit scripts- group...show me an error: phase 2
Error! Ovh_state-that variable already exists.
Line 10002 var 2800 ovh_state static
And it no works. No overhead working no mip working.
When Í clase the window where the group has runned, I save in a new file Í called OCP4NGX_test_02nuevocopia1.ssi
I go to ocb4ba configure And select pmdg 737, the OCP4NGX_test_02nuevocopia1.ssi file, exp/Master-518 And OVHMIP operations. And it not happens nothing. Thanks.

I edit file but var 2800 does not exist

I see there's impossible to resolve my doubt. I think mip and ovh doesn't work both. The scripts works fine separately but sioc software can not combine them. Thanks.

Can I send the ovh And mip scripts for separately to someone And combine them for me? Thanks.