Report bugs in OCP4787 for P3D here

[mvr1918]

Any bugs?

[martin]

Hi,
After installation of the OCP4787 driver and make the configarations acc the instructions there is a problem first when I select the QW 787 automaticly SIOC starts then only the IAS digit lights up the rest is blank when I touch the knobs on the mcp of the heading/altitute and vertical speed they light up also but than all inputs are very erratic that means every input on on the mcp gives all kind of different inputs in the digits also the heading input is counter clockwise so for a richt turn you need to give a left input on the mcp.
So is it normal that you do not go to the addon menu and selecting the OCB4A.
For your info I have the latest version of SIOC and all PMDG works fine.


Regards martin.

[Eytan_Ofir]

http://prntscr.com/l92z2s dosent work

[mvr1918]

Martin:

then only the IAS digit lights up the rest is blank

Bug1, now corrected in the new driver sent out

also the heading input is counter clockwise so for a richt turn you need to give a left input on the mcp.

Bug 2, now corrected in the new driver sent out.

So is it normal that you do not go to the addon menu and selecting the OCB4A

Not a bug, as stated in documentation , the driver starts itself if airplane loaded is an QW 787. No need to select in OC4BAv4.

[mvr1918]

Eytan_Ofir:

SOCKET ERROR 10006

This is not a bug, but an issue to be solved on your PC.

This means most likely that SIOC.exe does not accept the call from the QW787Client.dll running in Prepar3Dv4 or FSX/FSX-SE.

Check your FireWall program setting and make sure that both Preap3Dv4 or FSX/FSX-SE and SIOC are allowed apps through the firewall program.

Also, make sure you are using the latest SIOC version 7.03 or above.

[Eytan_Ofir]

Ok i will chack that thanks,
in the meantime could you check my problem at the x plane forums?
thanks again
so i tested it and still dosent work i created rulles with in the firewall witch allows them through but no luck

[Eytan_Ofir]

problem resolved bye reinstalling sioc

[mvr1918]

problem resolved bye reinstalling sioc

Glad you got it working. SIOC v7.03 is a MUST for this driver

[mvr1918]

Latest bug status for OCP4787 for P3Dv4:

ZERO active bugs:)

[martin]

Hi,
Thanks for your reply I updated the drivers now everything shows up on the mcp during start up the heading rotation is ok but now I cannot activate the speed button on the mcp only when i pushed the AT button whit the mouse on the QW mcp the light in the speed button on the mcp comes on and also i have still the problem with the erratic behaviour of the speed/heading and altitute inputs when i turn the Rotary 1 click the readout is correct but the next click the readout is suddenly much more as 1 click this happens for all rotary's

Regards martin.