www.flightsim4fun.com - rksoftware

all needles starting at the end possession apu egt and cabtemp work and fuel temp but but duck press psi going nuts needles start on top wen it connect then move all the way to the center but if i turn off apu bleed or iso valve needles wont move at all if i disconnect all needles move to the up possession i followed the guide got the other 3 to move but duck wont thank u

DO you have the OpenCockpit built Overhead or your own built Overhead?

build my self

im using pmdg but i also using ifly i got ifly set up but this one is a little harder

Try to see in SIOC/IOCPConsole what is really happening with the data sent to the Servos. When Servo moves in the wrong direction it is due to the Servo brand used. You can change the script to make them move correctly. Take a look at the http://www.flightsim4fun.com/how-to.html to see get some info about servo scripts.

As the script works fine with Opencockpit built modules and my OVH, the issue is your OVH setup. DO you have a complete OVH setup?

i looked at the script and made the changes to get the other one to work just this one not working for me and yes i have the full set up opencockpits servo

have you looked at the data from IOCPConsole and what does it tells you?

i looked it today seems its not seding all the values from the sim

i just retested it all agian apu sends the value the rest of the over head gauges its not being sent correct thats the problem

Then you have made some mistakes to the script when you edited it. The original script works OK