www.flightsim4fun.com - rksoftware

Hello
can anyone tell me how to revers the direction of the servo in my case the flap gauge.
I had a bit of a melt down and seem to have fried the servo as well as the servo card ,so i ordered a new card and I replaced the servo with a new one i had in the modeling shed.
i am not sure why but the flap needle is going backwards ? probably because the servo gear train has a extra gear or something . i also think the new servo has less travel but one thing at a time .
so if anyone knows a way to revers the direction of the servo by editing the scripted i would appreciate the help
thanks
Tim

update
I have checked again with sioc monitor and the servo will only go as far as flap 25
I have ordered some servos from amazon the same servo that came with the gauge the tower pro sg 90 hope fully that is all it takes to fix this
Tim

yes. turns out getting the exact same servo that came with the gauge fixed the problem. flap gauge now goes in the correct direction and has the right travel

Marked as SOLVED