www.flightsim4fun.com - rksoftware

Hi,


I got the latest update and have tried to install it.

I followed the instructions in the e-mail and also read the Documentation.

My NGX/PMDG Op C. are up to date.


On my first attempt, the script and module were automatically entered when selecting 737 as Cockpit in Config.

However, when exiting Config and selecting the 737-icon, the software started automatically (I did not even click the cockpit-icon), then nothing happened.


I tried to change in Config again, but things went corrupt.

After this, I have tried to re-install OC4BA again, but now, I can chose the cockpit but I get the crash message everytime I try to select the script:

All the best,


Johan



EDIT: I have also tried to uninstall both OC4BA and SIOC, but the result after this is the same. AND in Config, the Active Cockpit is not even detected now.

It works for others, so it must be something you do wrong.


If you do not use SIOC for anything else than the OC4BAv4 and Opencockpits I suggest that you
Uninstall both SIOC and OC4BAv4 and delete the SIOC folder with all its files.

Then
Install SIOC
Download
Beta2 of OC4BAv4 (version 4.4)

Unzip to any folder
Run as Administrator the OC4BAv4 Setup and make sure all OC4BAv4 files are going to SIOC folder
Start OC4BAv4 and click Config
Select PMDG B737 in Cockpit box
Select OC4BAv4_v4.4.ssi from Script box

Now you should have both the script and the MCP listed in the Cockpit configuration box
Close Config

Start your flightsim and a PMDG B737 airplane
Start OC4BAv4 from the flightsim’s Add-on menu
Click the B737 airplane image

Now everything should be OK.


Tell me your result after follow this procedure.

I tried Roar's checklist, but still no luck.

Roar then took his time to remotely control my PC and search for a solution.

In the end he discovered that my .Net Framework was not up to date. -MY BAD.



Anyhow, many thanks to Roar for his time.



Safe landings,


Johan

SOLVED

mvr1918 wrote:SOLVED

U bet.