www.flightsim4fun.com - rksoftware

Hello,

I currently have a setup consisting of the following:

USB Expansion card
Master Card
Inputs Card

I am tring to setup a overhead panel

I have wired the Ground PWR switch to my inputs card, and conntected all the cables for the cards.

When I check in my SIOC monitor, the input shows as I switch it (ON) - OFF - (ON) (lighting green)

I therefor tried editing the OCP4NGX_4.0, and replaced the line:

Var 0010, name GND_PWR_OFF_SW, Link IOCARD_SW, Device 30, Input 65 // Gnd Pwr Off SW

to

Var 0010, name GND_PWR_OFF_SW, Link IOCARD_SW, Device 30, Input 1 // Gnd Pwr Off SW

As Input 1 is the switch flashing green when pressing my switch in the SIOC monitor.

I then open OC4BAConfig and press PMDG 737, choose the OCP4NGX_4.0.ssi, and select my device.

I then bootup Prepar3D, and load the PMDG, and after that I open OC4BA selects the 737 and opens the cockpit, and then 0C4BANGX loads up.

Although when I hit my switch, nothing happens in the PMDG.

I appreciate your help and time.

I have closed this as the problem has been solved via private emails.