www.flightsim4fun.com - rksoftware

Hello roak:

I was wondering if you could help me solve my little problem, sorry if my English is a bit bad.

I tell you I have two computers FSX and another one where I connected the following:

1 usbexpansion
3 master
1 usb stepper
1 usb servos

Both computers have installed the SIOC see 5.0B5.

Well install the OC4BA Plus 737NGX in FSX and I could not find that detected the Master Cards me another computer in the OC4BAConfig. Good ment once if but it was like opening two sioc at once on the same pc fsx.

You know how to make all recognize? or esque OC4BA have to install on computer cards (although that's not saying the tutorial) ?.

A greeting and thanks.

Hi,

OC4BA v3 should be runned from the sane PC as having the FSX installed. It has not been tested with network configuration.

I run everything from the same computer. The SIOC and OC4BA take only 1% of the CPU load and you will not get any negative influence
in FSX.

As I have only 1 PC set up I have no way of testing network configuration.

Roar

Hi
I will send you a special ocp4ngx driver that can be used
In a network setup

What is the ip address of the computer that is running
the IOCARDs and the Sioc server?

hi thanks for the answers !!!!! my ip
192.168.1.39 and sioc same server