Servo Setup USB Plus
Posted: Fri Oct 07, 2022 11:14 am
Hi,
Can anyone talk me through a setup and calibration for the USBServosPlus with the new style scripts (6.1) for MSFS. I had mastered the old P3d (script 5.5) style setup of initial point of reference and editing the scripts for that value, then changing the multiplier to adjust the amount of servo arm throw / calibration factor.
The new scripts look completely different and are giving me some strange results in that the FS values and what the needes are showing are way out. I've only altered the L C and R values in the initial outputs device, is this correct?
Also in the USBServosPlus application should I be setting the servo limits upper and lower in that so that the needles dont top or bottom out or should I just be letting them run full range 0-1023
Any help would be appreciated,
Many Thanks.
James
Can anyone talk me through a setup and calibration for the USBServosPlus with the new style scripts (6.1) for MSFS. I had mastered the old P3d (script 5.5) style setup of initial point of reference and editing the scripts for that value, then changing the multiplier to adjust the amount of servo arm throw / calibration factor.
The new scripts look completely different and are giving me some strange results in that the FS values and what the needes are showing are way out. I've only altered the L C and R values in the initial outputs device, is this correct?
Also in the USBServosPlus application should I be setting the servo limits upper and lower in that so that the needles dont top or bottom out or should I just be letting them run full range 0-1023
Any help would be appreciated,
Many Thanks.
James