Page 2 of 2
Re: MCP works for 2 seconds then goes blank[SOLVED]
Posted: Wed Jan 10, 2018 9:01 pm
by dreak
tomorrow i will try the IOCPConsole and I will try reinstall, because before the update everything was ok, and if i use mouse and click/turn the knob, the mcp panel is light on but showing number that don't give any sense, then after another 2 seconds it going black again.
Re: MCP works for 2 seconds then goes blank[SOLVED]
Posted: Thu Jan 11, 2018 11:58 am
by dreak
I just found straige thing, I used IOCPConsole to test knobs, before it's goes blank, when I turn the knob, the numbers shows on logs, after it goes blank, the number start shows and and don't stop, I will try another usb port to test and I will make reinstall
Re: MCP works for 2 seconds then goes blank[SOLVED]
Posted: Thu Jan 11, 2018 12:58 pm
by dreak
Problem solved! I just found that I used cable extender that caused all problem, after I connect MCP direct to USB, problem is gone, thank you very much for your help!
Re: MCP works for 2 seconds then goes blank[SOLVED]
Posted: Thu Jan 11, 2018 7:02 pm
by mvr1918
OK topic closed