Oi4FS & SiOC Crashed all the Time[SOLVED]

[mvr1918]

. i have started SIOC, then i started Oi4FS, The i do double click on the ngxu, SiOC is going Disconnected and started new, after some seconds it crashes.

I am a little confused.

The right thing to do for you is.

Start Oi4Fs, click an airplane image to start SIOC and then the correct airplane driver.

or just click the Oi4FS AutoStarter, that will start SIOC and then the the correct airplane driver based on which airplane is running in MSFS.



Oi4FS should stay open until it is closed by the user.

[xxlmash]

Start Oi4Fs, click an airplane image to start SIOC and then the correct airplane driver.

That the way i do it

[mvr1918]

just to clarify

Start Oi4Fs, click an airplane image to start SIOC and then the correct airplane driver.

Once Oi4FS is running

either
click the an airplane image which start both Sioc and the airplane driver
or just
click Oi4FS Autostarter

[xxlmash]

first i start Oi4FS, then i click the NGUX Airplane - the SIOC is starting from alone

of 50 try, it works 1time - that it loads correctly

I'm really close to installing the CRJ if it works then. But actually, I don't want that. But to rule it out.

I´m going to install the CRJ...

[xxlmash]

it worked at the first Try with the CRJ

https://ibb.co/cccZrZz

[mvr1918]

If you haven't tried it yet. Try to start Oi4FS as administrator. It can be a Windows issue.

[xxlmash]

Have u read my private message?

[xxlmash]

If you haven't tried it yet. Try to start Oi4FS as administrator. It can be a Windows issue.

I started always Oi4FS as Administrator

[mvr1918]

Yes, I read the PM.

Some modules will work but not all. This is because some airplane uses default SimConnect Events and Variables for some functions.

But to have all modules working as specififed a special driver is needed.

[xxlmash]

What is the next step Roar, did u have any ideas? Why is it working with the CRJ?

Did i have to Activate the Developer Mode in MSFS?

BR Alex