Which script lines cut fuel lever

[Sudqui69]

Hi.
Which script lines control the cut fuel lever.
I can not find them.
Regards.

[Sudqui69]

Hi, I refer 737 pmdg. regards.

[mvr1918]

I do not believe these inputs have any script code implemented in the default script coming with Oi4FS.

You most likely need make a few input lines in the script yourself.
See this topic to find the Variable numbers to be used:

https://www.flightsim4fun.com/Forum/vie ... php?t=1075

[NobbyC_B738]

to make it a little easier for you:

the fuel lever are called ENG1_ and ENG2_START_LEVER in Roar's control stand variable list.

2323 = CONTROL_STAND_ENG1_START_LEVER
2324 = CONTROL_STAND_ENG2_START_LEVER

Please see this topic where same question came up and was answered.

https://www.flightsim4fun.com/Forum/vie ... php?t=1215

[Sudqui69]

Thanks for answering.
As you know for me it is very complicated to understand all this.
I am going to try with a third party software easier.
Thanks again.

[Sudqui69]

to make it a little easier for you:

the fuel lever are called ENG1_ and ENG2_START_LEVER in Roar's control stand variable list.

2323 = CONTROL_STAND_ENG1_START_LEVER
2324 = CONTROL_STAND_ENG2_START_LEVER

Please see this topic where same question came up and was answered.

https://www.flightsim4fun.com/Forum/vie ... php?t=1215

Thanks, I´m going to try,
I only put these two lines in the script and it works?
Regards.

[NobbyC_B738]

1) YES, you have to put 2 lines into the script, but the correct ones:

fuel_lever_command.jpg (25.17 KiB) Viewed 87 times

2) and NO, it will not work automatically. The most important thing is to change the device numbers and input numbers (red markings) according to your hardware.

the lines work for me, because I have a custom wired TQ connected to MIP device 31. You must find out how your fuel lever switches are wired and change the numbers accordingly.

Please read again topic that I linked previously. Most of your questions are answered there:

https://www.flightsim4fun.com/Forum/vie ... php?t=1215