PMDG B777 in P3D

[escasoni.1]

Apologies for this sumbission as it concerns P3D rather than MSFS, but I've been emailing Roar for days now but all are returned as failed delivery.

I recently purchased and installed Oi4FS to run with P3Dv4 but cannot get my MCP and EFIS modules to show any readouts when operating the program. All my planes, Open Cockpit modules and script files are populated in the configuration option, and the correct script file appears in column 5 when selecting the B777.
Selecting the FLY option and clicking the 777, SIOC connection screen appears briefly, then the Oi4FS screen disappears after a few seconds but there is no connection to my module readouts.
OCP4 files 777X.bmp and driver files have been transferred over, with the script file renamed as advised and a check of 777X_options.ini shows the [SDK] EnableDataBroadcast=1 to be present.

I'm at a loss as to what to try next, so is there anything else I could check

Ron

[mvr1918]

What is the text in the PMDG B777.ini file you have in Oi4FS folder?

Verify that you have
OCP4777X.bmp
OCP4777X.exe
PMDG B777 v4.5.ssi

in Oi4FS folder

[escasoni.1]

THanks for your reply.

Yes, I confirm that these files are in SIOC

Ron

[mvr1918]

Just to clarify
The script for the 777 should be named PMDG B777-P3D.ssi

If you still have the problem do the following:

Make a zip file of your SIOC folder.
Copy the SIOC.zip file to your ONEDRIVE and make a share link for it and send to roarkrsp@gmail.com