sioc and OC4BA v4

[gikke]

I have no card yet, but i ordered the USB output card since all other inputs are done already.
I have P3D V4.5, working well with PMDG737 NG.

I install SIOC v 7.03B2, test afterwards, seems to be OK, FSUIPC OK.
Then i install the driver OC4BAv4, in the same folder als the SIOC software (sioc.exe etc) is installed.
I added the OC4BAv4 in my P3D add-on menu.
When i test everything, i get an error popup saying ‘ “ is not a correct integer value” in the sioc.exe.

It seems to me that the sioc.exe might have started up several times.

Someone any idea ?
Thx, greets,

[Mitchthe1]

Hi Everyone

I am having the same issues as listed above
Any solutions would be appreciated

[mvr1918]

This error indicates that you do not have any configuration set in the SIOC.ini file or that this file is missing.

The Sioc.ini should be located in the SIOC folder with the rest of the SIOC and OC4BAv4 files.

You can create a new empty SIOC.ini if it is missing by starting OC4BAv4 /Config and go to the File menu

Hope this clear your problem