combine 2 scripts

[sudqui]

Hi. I want to combine 2 scripts, one of this OVHD and another one MIP.
I make each one for separately. Then I open SIOC-edit script-group-run and I think a new script is created.
But, after when I configure OCBBA I choose the new script, the module, and in 4 box operations , what I have to select in here?
OVH-FWD and MIP?
What is the right way to do it?
Thnks.

[mvr1918]

In order to make this correct, you must fully understand the SIOC handling of hardware and software.

If you have both OVH and MIP functions defined to the same Expansion/Master cards you should do the following:

As the IDX number is the device number in your script, i.e. 30

In the OC4BAv4.ini, if you have 3 Master cards
Delete OVH-FWD IDX30m2
Add OVHMIP IDX30m3


Then you select OVHMIP as Operations when you set up your configuration.

Hope this was clear enough.

[sudqui]

Hi. Thanks for the answer. Í undertand it. The problem now is the following: when I run in the sioc-edit scripts- group...show me an error: phase 2
Error! Ovh_state-that variable already exists.
Line 10002 var 2800 ovh_state static
And it no works. No overhead working no mip working.
When Í clase the window where the group has runned, I save in a new file Í called OCP4NGX_test_02nuevocopia1.ssi
I go to ocb4ba configure And select pmdg 737, the OCP4NGX_test_02nuevocopia1.ssi file, exp/Master-518 And OVHMIP operations. And it not happens nothing. Thanks.

[sudqui]

I edit file but var 2800 does not exist

[sudqui]

I see there's impossible to resolve my doubt. I think mip and ovh doesn't work both. The scripts works fine separately but sioc software can not combine them. Thanks.

[sudqui]

Can I send the ovh And mip scripts for separately to someone And combine them for me? Thanks.