nawty servo[SOLVED]

[happy]

Hello
can anyone tell me how to revers the direction of the servo in my case the flap gauge.
I had a bit of a melt down and seem to have fried the servo as well as the servo card ,so i ordered a new card and I replaced the servo with a new one i had in the modeling shed.
i am not sure why but the flap needle is going backwards ? probably because the servo gear train has a extra gear or something . i also think the new servo has less travel but one thing at a time .
so if anyone knows a way to revers the direction of the servo by editing the scripted i would appreciate the help
thanks
Tim

[happy]

update
I have checked again with sioc monitor and the servo will only go as far as flap 25
I have ordered some servos from amazon the same servo that came with the gauge the tower pro sg 90 hope fully that is all it takes to fix this
Tim

[happy]

yes. turns out getting the exact same servo that came with the gauge fixed the problem. flap gauge now goes in the correct direction and has the right travel

[mvr1918]

Marked as SOLVED