Hello,
First excuse for my bad english.
I have no plugandplay module only opencockpit cards (4 master cards).
I use the script Ocp4ngx_V3.1 ,i’m trying to reprogram,input,idx...
I can not find the lines for the flaps to change the input number.
I write new line with var 2334 for flaps pos5 for example but dont work.
thank you
script flaps
Re: script flaps
You are right. I have no script code for FLAPS handle as I use the FSUIPC to handle the FLAPS.
Using Var2325 and alternate between values 8192 and 8193 the FLAP handle moves downwards.
Using Var2325 and alternate between values 0 and 1 the FLAP handle moves upwards.
Using the other Vars for the specific setting you should use a -1 value.
You can try this when you are in IOCPConsole and setting the values to the Vars to check it out before making the script.
Using Var2325 and alternate between values 8192 and 8193 the FLAP handle moves downwards.
Using Var2325 and alternate between values 0 and 1 the FLAP handle moves upwards.
Using the other Vars for the specific setting you should use a -1 value.
You can try this when you are in IOCPConsole and setting the values to the Vars to check it out before making the script.
Re: script flaps
Hello
Is it possible to use the var 2334 flaps5,2328 flaps10.......or not?It would be so easy.
If not possible with the pmdgngx, what is the var 2334,2328........ in the event list?
thank you
marc
Is it possible to use the var 2334 flaps5,2328 flaps10.......or not?It would be so easy.
If not possible with the pmdgngx, what is the var 2334,2328........ in the event list?
thank you
marc
Re: script flaps
The answer is YES.
as written earlier
Using the other Vars for the specific setting you should use a -1 value.
This means you use 2334 etc with -1 to set a specific FLAPS setting
Try with IOCPConsole and you will find out.
If you are new to SIOC, the best way to learn is to TRY
as written earlier
Using the other Vars for the specific setting you should use a -1 value.
This means you use 2334 etc with -1 to set a specific FLAPS setting
Try with IOCPConsole and you will find out.
If you are new to SIOC, the best way to learn is to TRY
Re: script flaps
Hello,
I fail to operate the flaps .Can you give me an example of script to program flaps 5.
Var flaps 5 is 2334 in the event list.
Input switch flaps 5 is 216.
This will help me enormously.
thank you
Marc
I fail to operate the flaps .Can you give me an example of script to program flaps 5.
Var flaps 5 is 2334 in the event list.
Input switch flaps 5 is 216.
This will help me enormously.
thank you
Marc
Re: script flaps
Hello
The right word "TRY TRY TRY".
After 1 day i found my error.
I run ocp4ngx v2.4.8 in place ocp4ngx v2.5.5 i try with iocpConsol and it works.
Thank you
Marc
The right word "TRY TRY TRY".
After 1 day i found my error.
I run ocp4ngx v2.4.8 in place ocp4ngx v2.5.5 i try with iocpConsol and it works.
Thank you
Marc
Re: script flaps
Yes, by trying you learning in the most effective way