www.flightsim4fun.com - rksoftware

OIPMDG737 is only necessary if you use an Autopilot from OpenCockpit (Hardware)
In all other cases for a Motorized Throttle is only my Programm necessary.

I am in contact with PMDG and they told me, that it's no issue, that the N1-LED does not lit. :roll: He wrote: There is a world of difference between the 777 SPD function and the 737 N1. One is MCP SPD the other is FMC Thrust. Sorry, old mind has a slow response: Boeing philosophy is that you tell t...

Hello from Austria, I hope you can help me at a small issue with my Motorized Throttle: - FS2020 - B737 PMDG - Autopilot V2 OpenCockpit When i press the TOGA-Button the levermotors should start with the N1-LED from MCP. But this LED does not lit! It only comes, when I switch on the AP1 and/or AP2. B...

Here is the TXT file: // ***************************************************************************** // * Config_SIOC ver 5.0B5 - By Manolo Vélez - www.opencockpits.com // ***************************************************************************** // // * Editor: Hermann Hummer // // * FileName ...

Hello Charlie, very sorry for the long delay. I didnot receive a message that you wrote and I did not visit the site for a long time. The throttle runs well with PMDG 737, only TOGA or N1 is not working, you must lift off by hand throttle. Later everything work, both levers and elevator trim. With P...

mvr1918 wrote: ↑Wed Jun 26, 2024 9:36 am I will release it on Monday 1. July

Hello from Austria!
Thanks for the good news.
I am very keen to get it
Best wishes Hermann

Thanks a lot!

Brgds Hermann

There are push rotaries both on speed and alt. Both are connected to the board, but not shown as key. When I add two buttons to the MCP and connect it to eg. Mobiflight board, could yout tell me the offsets for both Alt Intv and Speed Intv? It's just an idea because it is not so good to have PMDG an...

Is it possible to press the ALT rotary switch to activate ALT INTV?
When i press it, it clicks. But I don't know the address of it.
BR Hermann

Hello from Austria!

The MCP v2 has no Button for ALT INTV.
Is there a way to activate it nevertheless?

Thanks and regards

Hermann