www.flightsim4fun.com - rksoftware

For some unknown reason to me I do not have this issue anymore. Driver starts again without any warning.

However I could not find the information you are refereeing to on my system (Win 11 NL).

To get default Squawk Code 2000 I changed XpndrCode=8192 (PanelState file)

[TCAS]
Powered=0
XPNDR=0
ALT SOURCE=0
Mode=0
XpndrCode=8192
ActiveTCASAural=-1

Gr, Mladen

Roar, thank you for your suggestion.
Well, it seems that 777 handles things differently then 737 regarding the "Panel State" files. I followed Han's instructions and the sim did not overwrite modified values. Thanks Hans.
Have fun guys,
Mladen

Hans, thank you for your suggestion. I'll give it a try again since my changes in "Panel State" file were replaced with original values as soon as i started a new flight.
Groetjes, Mladen

I have the same issue.
Gr, Mladen

Is it possible to set COM radio to default (active) 122.800 value and the ATC Squawk code to 2000 when the script is started?
I could not achieve this by saving Panel State in PMDG.
Gr, Mladen

When I close (shut-down) simulator Oi4FS24 nicely closes too but OC modules (hardware) are still ON, at least displays and LEDs are still brightly shining .
Is there a software routine in the driver which could turn-off modules completely? ... cold 7 Dark
Have fun,
Mladen

Hi, I noticed that if I dial COM 1 radio on OC module for one step COM1 Radio on VC panel will change to 122.805 but on OC COM module will stay at 122.800. If I turn one step more on OC module value will change to 122.810 ans so it will on VC COM panel. Shortly ... I can not dial for example 122.805...

A/T LED will not lit when A/T is armed. Switch in VC (Virtual Cockpit) moves in ARM position and green light illuminates but LED on the OC MCP does not lit. I use 1.2 driver ************************************ [SIOC] IOCP_port=8092 IOCP_timeout=4000 Minimized=Yes toggle_delay=20 [IOCARDS MODULE] IO...

I can confirm that ATC selector switch is not operational. While selecting different Modes on OC ATC module the selector knob in the VC (Virtual Cockpit) is moving but no signal is sent to ND (Navigation Display) or Pilot clients on vPilot or IVAO Altitude.
I use 1.2 driver
Gr, Mladen